AUTONET TV

When Are Your Tires Worn Out?

Hey Herndon area drivers, are your tires worn out? What is the standard for our VA streets? How can you tell on your vehicle?

While there may be legal requirements for the Herndon area, there are safety concerns that go beyond meeting minimum replacement mandates.

Two-thirty-seconds of an inch is the depth of the tire tread wear indicator bars that US law has required to be molded across all tires since August 1, 1968. When tires are worn so that this bar is visible, there's just 2/32 of an inch – 1.6 millimeters – of tread left. It's that level of wear that's been called into question recently.

We're referring to the tread depth on a tire, it can't move surface water out of the way and you start to hydroplane.

In a safety study, a section of a test track was flooded with a thin layer of water. If you laid a dime on the track, the water would be deep enough to surround the coin, but not enough to cover it.

A car and a full-sized pick-up accelerated to 70 miles per hour, or 112 kilometers an hour, and then made a hard stop in the wet test area. Stopping distance and time were measured for three different tire depths:

• New tire tread depth
• 4/32 of an inch, or 3.2 mm
• 2/32 of an inch, or 1.6 mm

So what happened with the 2/32 inch/1.6 mm tires on the car? Get this – when the car had traveled the distance required to stop with new tires, it was still going 55 mph/89 kph. Stopping distance was nearly doubled to 379 feet/116 meters, and it took 5.9 seconds.

Wow! That means if you barely have room to stop with new tires, you would hit the car in front of you at 55 mph/89 kph with the worn tires.

Now, with the partially worn tires – at 4/32 of an inch, or 3.2 mm – the car was still going at 45 mph/72 kph at the point where new tires brought the car to a halt. It took nearly 100 feet, or about 30 meters, more room to stop and 1.2 seconds longer. That's a big improvement. We can see why Consumer Reports and others are calling for a new standard.

Of course, stopping distances were greater for the heavier pick-up truck.

How do you know when your tires are at 4/32 inch or 3.2 mm? Easy; just insert an American quarter into the tread. Put it in upside down. If the tread doesn't cover George Washington's hairline, it's time to replace your tires. With a Canadian quarter, the tread should cover the numbers in the year stamp.

You may remember doing that with pennies. A penny gives you 2/32 inch, or 1.6 mm, to Abraham Lincoln's head. The quarter is the new recommendation – 4/32 inch, or 3.2 mm.

How do people feel about replacing their tires earlier? Well, tires are a big ticket item and most people want to get the most wear out of them that they can. But do you want that much more risk just to run your tires until they are legally worn out?

For us, and we would guess for many, the answer is "no".

McLearen Shell
3043 Centreville Road
Herndon, VA 20171
(703) 318-7744
http://www.mclearenshell.com

The Part You've Never Seen (Flat Tires and Solutions)

They say your vehicle has one, but you've never seen it.  And you might not even know it if you stumbled on it accidentally.

We're talking about the jack, that tool that allows you to lift one corner of the vehicle up so someone can change a flat tire.

So you say you'd never try to change a flat anyway, so you don't care where it is.  But one day, you may find yourself in a spot where you're stranded with no cell service and you'll need to at least know the basics of what to do.

Well, here's the ironic part.  Many of today's vehicles don't even have jacks and spares!  Recently, manufacturers have been saving weight by supplying another solution for a flat tire, such as an inflator kit that has a tire sealant in it, or a small compressor.  If your vehicle has one of those, it's a good idea to get to know how to use it before you need to use it.  Hopefully you'll be able to call roadside assistance and they can take care of things, but circumstances may prevent help from coming for a long time. The next time you're here at McLearen Shell for routine maintenance, ask one of our pros to show you the basics of your vehicle's flat tire tools.  Consider watching an online video, too; there are plenty out there and may be specific to your make and model.

Some vehicles have a space-saving spare, a smaller one that is meant to get you on the road long enough to find a place to have it repaired or replaced.  Those vehicles will also have a jack.  Then there are vehicles that have a full-size spare tire and a jack.  Again, you may prefer to call roadside assistance, but if no one is available or reachable (which is sometimes the case in a major storm), you may have to fix your own flat.

Some drivers do a "dry run" of changing a tire in their driveway during daylight hours so they at least know where the jack and spare are and how to use them.   Our service experts may be able to help you locate each part and give you some tips.  And again, there are many videos online that can show you the fundamentals of jacking your make and model of vehicle. 

Nobody relishes a flat tire.  You may be lucky and never have to change one.  But in this case, a little knowledge is better than no knowledge at all.  In the unlikely case you are stranded at the side of a highway at night in the middle of the rain with no cell service, you'll at least be one step ahead.

McLearen Shell
3043 Centreville Road
Herndon, VA 20171
(703) 318-7744
http://www.mclearenshell.com

Your Vehicle is Talking to YOU (Service Warning Signs)

Your vehicle may be like that famous battery bunny, the one that just keeps going and going.  But while it may seem sometimes like you never need to take your vehicle in to be worked on, there are some things you should keep your eyes, ears and nose out for. They are warning you about something that needs attention at your vehicle service facility.

• If a warning light is on, don't ignore it; do something about it.  There are warning lights for battery, oil, engine heat, tire pressure… you name it.  And the manufacturer put them there for a reason.  They're telling you something isn't normal. So when one goes on, have it checked out soon, especially the blinking Check Engine light.  The earlier you have any warning light issue diagnosed, the more likely you are to avoid a more serious problem.
• If your vehicle is vibrating or shaking, it's not only annoying, it could signal trouble.  You can bet your vehicle didn't do that when it came out of the factory! If you can feel a vibration in the seat of your pants or shaking in the steering wheel, head on over to your service facility and have them diagnose what is causing it.
• Smoke coming out of anywhere in your vehicle is a signal (smoke signal, get it?) that there may be a troubling issue.  Likewise if you can smell something burning (like oil), the nose knows there's something amiss.  Time to find out what.
• If you aren't getting the distance you used to out of a tank of gas, it may not simply be your lead foot. A lot of vehicles will give you a digital readout of your latest mileage.  If your fuel economy takes a dip, take a trip over to your service facility.  You might have a sticky brake caliper… or it might be something as simple as your tires need more air.
• Yes, you know the dreaded puddle of something under your vehicle can be a bad sign.  It could smell sweet, it could feel oily.  But it means something is leaking.  Go get it checked.  Sooner is better when it comes to locating the source of a leak.
• If your brake pedal travels further than it used to while stopping, that could be compromising your ability to stop safely.  Also, if the brakes are making odd sounds, pulsating, grinding or squealing, they're screaming at you for attention.  Proper braking is a must for your safety and those drivers around you.

An old 80s TV show called "Knight Rider" featured a talking car.  You already have a vehicle that's telling you things all the time.  Give it a listen and it will keep you going safely down the road for many years to come.

McLearen Shell
3043 Centreville Road
Herndon, VA 20171
(703) 318-7744
http://www.mclearenshell.com

The McLearen Shell Basic Guide To Synthetic Oil

Synthetic motor oil has been around for a long time, and more and more new vehicles are leaving factories with synthetic in their engines. But a lot of drivers don't really know much about it.

Let's start with conventional oil – the kind folks are used to. Conventional oil is made up of naturally occurring hydrocarbon chains, which means its molecules are long and have various lengths. Like a pile of pencils, some of them new and some of them used.

Synthetic oil is man-made. Its molecules are more uniform and regular in shape – more similar to marbles than pencils. Some synthetic oil starts with a petroleum base that's modified and others are entirely synthesized from other materials.

Synthetic motor oil works better in both hot and cold temperatures. It's more chemically stable so it doesn't readily evaporate or break down in the high heat produced inside your vehicle engine. This means it resists turning to sludge, which is a real engine killer.

Remember that marbles and pencils thing we were talking about? Well, that makes synthetic oil slipperier than conventional oil which means less friction in your engine. Your vehicle engine runs cooler, wears less and lasts longer. You also get a boost in power and maybe even an improvement in fuel economy.

Synthetic oil also lasts longer so you change it less often – which is great for the environment. With longer oil change intervals, you need an oil filter specifically built for the longer service life of synthetic oil. Talk with your friendly and knowledgeable McLearen Shell service adviser about synthetic oil and synthetic blends – they might be just what you need to improve engine performance and extend the life of your vehicle.

Give us a call.